The first step in paperclip lockpicking is to make several small, 45 degree bends in the paperclip. You may have to experiment a bit to find the right amount, but three bends are enough for most locks. Once you have the right amount, you can start the lockpicking process.
Tricks to picking a lock with a paperclip
One of the best ways to open a locked door is by using a paperclip. There are a few tricks that you need to learn in order to pick a lock with a paperclip. The first thing you need to do is straighten a paperclip before you start the process. You also need to know the proper speed and tension to do this. A paperclip that has an extra loop handle is recommended.
The next trick that you will need is a tension wrench. This is used to apply pressure to the pins inside the lock. You should always remember to apply just enough pressure, as too much pressure will bend or break the paperclip, while too little pressure will not work.
Using a bobby pin
Bobby pins can be a handy tool when you are locked out of your home. These inexpensive tools can be used to open doorknobs, bathroom doors, or bedroom doors. Bobby pins are light and easy to manipulate, but there is some learning curve involved. You will need to know which direction to push the pin in.
To make a bobby pin lock pick, bend the tip of the pin inside the lock and push it to the left two to three inches. This will create a loop and give you a little more pressure on the lock.
Using a paperclip
A paperclip can be turned into a tension wrench or a tiny lock pick. Make sure to use a thicker paperclip than a thin one because a small one may bend or break the lock. You should use only enough tension to work the lock, but not too much. A good rule of thumb is to not bend the clip more than 20 degrees.
You can use a paperclip to pick most types of locks. Paperclips are good for cheap, simple locks with wide keyways. Paperclips can’t pick locks with smaller keyways or more security features. For more advanced locks, however, you should consider investing in a lock pick.
Combination lock picks with a paperclip
Combination lock picks with a paper clip can be a handy way to open locked lockers or closets. These types of locks contain a dial in the locking mechanism that moves the locking bolt and unlocks the door when the dial is turned in the right direction. A paperclip can be shaped to fit these locks, and it can be used as a tension wrench or a pick.
The paperclip should be bent into a “U” shape, about 3/4 inch long. It should be flexible enough to bend inside the lock, but not too long or it will fall out. You can buy a lockpicking set online, or make your own using Wikihow.
